[Released] Ultimate Zero [Commercial]

Comments

• barbult Posts: 27,479

  4:07AM edited 4:08AM

  I don't understand the listing of Bend twice in the top section of Ultimate Zero Figure. The pose on this figure modifies more than a couple bends. Both Bend entries have check marks next to them. Both are named identically, "Bend". How does one distinguish what they apply to? How would one know to check or uncheck either one? Bends are parameters, not properties. Something significant must be missing in this section. 

  

  

  

  Screenshot 2026-09-03 235528 affected properties Bend Bend.png

  1674 x 1356 - 397K

  Post edited by barbult at 4:08AM
• crosswind Posts: 10,246

  7:02AM

  barbult said:

  I don't understand the listing of Bend twice in the top section of Ultimate Zero Figure. The pose on this figure modifies more than a couple bends. Both Bend entries have check marks next to them. Both are named identically, "Bend". How does one distinguish what they apply to? How would one know to check or uncheck either one? Bends are parameters, not properties. Something significant must be missing in this section. 

  They seem to be some Pose Control properties coming from the root node of the figure. I couldn't reproduce the issue by just dialing rotation values on the thigh.

  Is there any Pose Control properties dialed on the G9 ? 

  

  

  SNAG-2026-9-4 0001.png

  2560 x 1392 - 636K
• barbult Posts: 27,479

  7:42AM

  I didn't save the scene. I'll have to round up that pose and try to recreate it tomorrow. Thanks for testing.

   
• RiverSoft Art Posts: 6,968

  3:26PM

  Karen said:

  Update is in DIM :-) Works like a charm now. 

  Thank you for confirming!